Thermal Stability and Corrosion Performance of Mineral Water and Commercial Coolant in a Hiace Engine

Authors

  • Ikhsan Ambia Department of Mechanical Engineering, Universitas Abulyatama Aceh, Aceh Besar, 23372, Indonesia Author
  • Iqbal Author
  • Muhammad Faisal Author
  • Nurhanifa Author
  • Lindawati Author

DOI:

https://doi.org/10.68728/jrlk.v1i2.7

Keywords:

Carbon steel, Commercial coolant, Corrosion rate, Engine cooling system, Thermal stability

Abstract

Automotive cooling systems must maintain stable operating temperatures while protecting metallic components from corrosion. However, mineral water is frequently used as an inexpensive substitute for formulated coolant. This study compared the corrosion rates of carbon-steel specimens and evaluated engine-temperature stability when mineral water and commercial coolant were used in a Hiace gasoline-engine cooling system. We used a quantitative experimental method at FR Auto Tune Workshop, Aceh Besar. We tested carbon-steel specimens measuring 5 × 2 × 0.2 cm (surface area: 22.8 cm², density: 7.85 g/cm³) in both cooling media. Engine temperature was monitored at 800 rpm, and corrosion was evaluated by visual inspection, mass loss, and corrosion-rate calculations. Commercial coolant produced an average engine temperature of 74.61 °C and a maximum of 88.3 °C, whereas mineral water produced an average of 78.53 °C and a maximum of 93.1 °C. Specimens exposed to mineral water developed reddish-brown rust, lost 0.05 g, and exhibited a corrosion rate of 0.489 mm/year. In contrast, specimens exposed to coolant showed minimal corrosion, lost 0.02 g, and recorded a corrosion rate of 0.196 mm/year. These findings indicate that coolant provides better thermal control, while its corrosion inhibitors reduce metal degradation. Therefore, commercial coolant maintained lower, more stable engine temperatures and reduced the corrosion rate by 59.92% compared with mineral water.

Downloads

Published

15-09-2026

Issue

Section

Articles

How to Cite

[1]
“Thermal Stability and Corrosion Performance of Mineral Water and Commercial Coolant in a Hiace Engine”, JRLK, vol. 1, no. 2, pp. 72–82, Sep. 2026, doi: 10.68728/jrlk.v1i2.7.

Most read articles by the same author(s)

1 2 > >> 

Similar Articles

11-11 of 11

You may also start an advanced similarity search for this article.