Mechanical Performance of Blockboard Before and After High-Pressure Laminate Surface Treatment

Authors

  • Yurnalis Department of Mechanical Engineering, Universitas Abulyatama Aceh, Aceh Besar, 23372, Indonesia Author
  • Mahyuddin Author
  • Muhammad Faisal Author
  • Lindawati Author
  • Iqbal Author

DOI:

https://doi.org/10.68728/jrlk.v1i2.10

Keywords:

Blockboard, High-pressure laminate, Surface treatment, Flexural performance, Compressive performance

Abstract

Blockboard is widely used in furniture and lightweight construction because of its favourable strength, workability, and affordability. High-pressure laminate (HPL) is commonly applied to improve surface appearance and protection; however, its effect on blockboard's mechanical performance requires further evaluation. This study compared the flexural and compressive performance of blockboard before and after HPL surface treatment. We used an experimental comparative method with uncoated and HPL-coated blockboard specimens. Flexural specimens measuring 21 × 5 × 5.4 cm and compression specimens measuring 5 × 5 × 5.4 cm were progressively loaded until failure using a testing machine, and their maximum loads were recorded. The flexural test showed that the maximum load decreased from 965.5 N for uncoated blockboard to 748.6 N after HPL application, representing a reduction of approximately 22.5%. Conversely, the maximum compressive load increased from 94.3 kN to 186.4 kN, equivalent to an improvement of approximately 97.7%. These contrasting results indicate that HPL affects blockboard performance differently under different loading conditions. Improved compressive resistance may result from surface reinforcement and better load distribution, whereas reduced flexural performance may reflect bonding quality, material structure, or stress concentration. The results suggest that HPL treatment substantially improves the compressive load capacity of blockboard but does not necessarily enhance its flexural performance.

Downloads

Published

15-09-2026

Issue

Section

Articles

How to Cite

[1]
“Mechanical Performance of Blockboard Before and After High-Pressure Laminate Surface Treatment”, JRLK, vol. 1, no. 2, pp. 104–113, Sep. 2026, doi: 10.68728/jrlk.v1i2.10.

Most read articles by the same author(s)

1 2 > >> 

Similar Articles

1-10 of 14

You may also start an advanced similarity search for this article.