Community Application of a Screw Press for Sago Starch Extraction: Processing Capacity and Starch Yield

Authors

  • Zul Adeha Department of Mechanical Engineering, Universitas Abulyatama Aceh, Aceh Besar, 23372, Indonesia Author
  • Mahyuddin Author
  • Muhtadin Author
  • Nurhanifa Author
  • Iqbal Author

DOI:

https://doi.org/10.68728/jrlk.v1i2.23

Keywords:

Sago starch, Screw press, Starch extraction, Processing capacity, Starch yield

Abstract

Sago is an important local starch source, yet manual extraction can require substantial labour and processing time. This study evaluated the performance of a screw press sago pressing machine as a potential technology for improving starch extraction. The objectives were to determine its processing capacity and starch yield under two material loads and to describe how the observed pressing times related to the resulting starch output. We used a descriptive experimental approach in the Mechanical Engineering Laboratory at Abulyatama University. We pressed grated sago in two trials using loads of 2.5 kg and 2.0 kg. We recorded material weight, pressing time, and recovered starch weight, and calculated processing capacity and starch yield. The 2.5 kg load required 30 minutes and produced 0.33 kg of starch, equivalent to a processing capacity of 5.00 kg per hour and a yield of 13.2%. The 2.0 kg load required 25 minutes and produced 0.25 kg of starch, with a processing capacity of 4.80 kg per hour and a yield of 12.5%. Average capacity and yield were 4.90 kg per hour and 12.85%, respectively. The larger load produced more starch and required a longer pressing time, while yields differed by only 0.7 percentage points. These findings indicate that the machine extracted starch under both tested conditions. Further trials with additional loads and repetitions are needed before determining an optimal operating condition.

Downloads

Published

15-09-2026

Issue

Section

Articles

How to Cite

[1]
“Community Application of a Screw Press for Sago Starch Extraction: Processing Capacity and Starch Yield”, JRLK, vol. 1, no. 2, pp. 233–239, Sep. 2026, doi: 10.68728/jrlk.v1i2.23.

Most read articles by the same author(s)

1 2 > >> 

Similar Articles

You may also start an advanced similarity search for this article.