Community Training on Safe Hot Air Rework Station Use for Electronic Component Repair
DOI:
https://doi.org/10.68728/jrlk.v1i2.22Keywords:
Hot air rework station, Electronic repair, Nozzle distance, Temperature distribution, Solder meltingAbstract
Hot air rework stations are widely used to remove and install electronic components, yet the temperature displayed on the control panel may differ substantially from the heat reaching a workpiece. This study examined a hot air rework station's thermal performance to support safer, more effective use in electronic repair. A quantitative experiment varied the set temperature (200, 300, and 400 °C) and nozzle distance (1, 3, and 5 cm), with three repetitions per combination. We measured actual temperatures using a thermocouple. We also assessed blower speed and solder melting time. At a 300 °C setting, mean measured temperatures were 244.47 °C at 1 cm, 228.87 °C at 3 cm, and 131.23 °C at 5 cm. Differences between set and measured temperatures ranged from 26.30 to 230.70 °C across the tested conditions. The blower operated at 7,797 rpm at a 300 °C setting. At that setting, solder paste with a nominal melting point of 153 °C melted in an average of 23, 31, and 42 seconds at 1, 3, and 5 cm, respectively. These findings indicate that nozzle distance affects heat delivery and the time required for solder to melt. They provide a practical basis for explaining temperature settings and nozzle positioning during community training in electronic repair. The results are limited to the tested device and conditions.